HHR L4-2.0L Turbo (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the ECT and tighten to 20 Nm (15 lb ft).
2. Connect the engine wiring harness electrical connector (3) to the ECT sensor.
3. Install the heat shield around the electrical connector, if necessary.
4. Fill the cooling system as needed. Refer to Cooling System Draining and Filling (See: Service and Repair/Cooling System Draining and Filling).
