HHR L4-2.2L (2007)
Positive: Service and Repair
Battery Positive and Negative Cable Replacement
Battery Positive and Negative Cable Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Open the junction block terminal cover.
3. Remove the junction block terminal nut (1).
4. Remove the positive/negative battery cable terminal (2) from the junction block terminal stud.
5. Remove the positive/negative ground nut (3) from the tie bar stud.
6. Remove the positive/negative ground terminal (4) from the tie bar stud.
7. Remove the positive/negative battery cable clip (6) from the engine control module (ECM)/transaxle control module (TCM) bracket.
8. Raise and support the vehicle. Refer to Vehicle Lifting.
