HHR L4-2.4L (2010)
10. Disconnect the LR brake pipe fitting (1).
Cap the fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
11. Remove the BPMV bolt (1).
Note: Do not remove the mounting pins unless it is necessary to aid in releasing the modulator assembly from the bracket.
12. Carefully remove the brake control module assembly from the BPMV bracket insulators by pulling straight upward.
Do not pry against the accumulator covers on the underside of the brake modulator assembly to release the mounting pins from the bracket
insulators.
13. If installing a new BPMV, remove the EBCM. Refer to Electronic Brake Control Module Replacement (With JL4) (See: Electronic Brake
Control Module/Service and Repair).
Installation Procedure
1. If installing a new BPMV, install the EBCM. Refer to Electronic Brake Control Module Replacement (With JL4) (See: Electronic Brake Control
Module/Service and Repair).
