HHR L4-2.4L (2010)
9. Connect the master cylinder primary brake pipe fitting (1).
Tighten the fitting to 21 Nm (15 lb ft).
10. Connect the EBCM electrical connector.
11. Install the cover to the ECM and the TCM.
12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair).
13. Program the EBCM. Refer to Service Programming System (SPS) (See: Testing and Inspection/Programming and Relearning/Service
Programming System (SPS)).
14. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle).
15. Observe the brake pedal feel after performing the diagnostic system check. If the pedal now feels spongy, air may have been in the secondary
hydraulic circuit of the brake modulator which may have been introduced into the primary circuit. If the pedal feels spongy, perform the Antilock
Brake System Automated Bleed Procedure (See: Brake Bleeding/Service and Repair).
