HHR L4-2.4L (2010)
5. Connect the master cylinder primary brake pipe fitting (1) and tighten to 21 Nm (15 lb ft).
6. Connect the master cylinder secondary brake pipe fitting (1) and tighten to 21 Nm (15 lb ft).
7. Install the underhood electrical center bracket and position the electrical center and the powertrain control modules to the electrical center bracket.
Refer to Underhood Electrical Center or Junction Block Bracket Replacement (See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Service
and Repair/Underhood Electrical Center or Junction Block Bracket Replacement).
8. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
9. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair).
