HHR L4-2.4L (2010)
1. Lubricate the CKP sensor O-ring seal with clean engine oil.
2. Install the CKP sensor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the CKP sensor bolt.
Tighten the sensor bolt to 10 Nm (89 lb in).
4. Connect the CKP sensor electrical connector (4).
5. Install the starter. Refer to Starter Replacement (See: Starting and Charging/Starting System/Starter Motor/Service and Repair).