HHR L4-2.4L (2010)
1. Install the positive battery cable to the inside the vehicle.
2. From inside the vehicle, route the engine compartment portion of the positive battery cable through the front of dash.
3. Install the positive battery cable to the body harness clip (4).
4. Install the positive battery cable clips (2) to the ECM/TCM bracket.
5. Install the positive battery cable terminal (1) to the junction block stud.
6. Install the positive/negative battery cable terminal (2) to the stud.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Install the junction block terminal nut (1).
Tighten the nut to 15 Nm (11 lb ft).
8. Close the junction block terminal cover.
