HHR L4-2.4L (2010)
Note: The power steering assist motor should engage evenly and with ease. If it will not engage the reduction unit wormgear then remove the
motor and try again. Do not force the motor and reduction unit together.
2. Install the power steering assist motor (2).
3. Grasp the power steering assist motor and hold it to the reduction unit while turning the steering shaft three full turns. This will center the and align
the power steering motor shaft and the reduction unit wormgear.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: Do not apply any load to the power steering assist motor while torquing the bolts or the realignment process described prior will need to be
redone.
4. Instal the power steering assist motor bolts (1) and tighten to 18.5 Nm (14 lb ft).
5. Connect the power steering assist motor electrical connector.
6. Install a new tie strap to the power steering assist motor.
7. Install the steering column. Refer to Steering Column Replacement (See: Steering Column/Service and Repair/Steering Column Replacement).
