HHR L4-2.4L (2010)
appropriate threadlocker.
Note: Failure to transfer the scribed marks may result in an off-center steering wheel.
2. If installing a new intermediate steering shaft then transfer the scribed marks made previously.
3. Position the intermediate steering shaft and seal assembly to the vehicle.
Note: Inspect the intermediate steering shaft seal from the engine compartment to make sure it is seated properly.
4. Seat the intermediate steering shaft seal to the body pass-through.
5. Align the scribed marks on the intermediate steering shaft to the scribed marks on the steering column shaft.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Connect the intermediate steering shaft to the steering column.
7. Install a new intermediate steering shaft bolt and tighten to 34 Nm (25 lb ft).
