HHR L4-2.4L (2010)
11. Remove all rear axle bushing bracket bolts.
12. Use the hydraulic lift table to lower the rear axle from the vehicle.
13. Remove the rear axle bushing through bolts and the park brake cable brackets.
Installation Procedure
1. Install the axle brackets to the axle bushings, with the alignment slot on the outboard side.
Note: The axle bushing through bolts must be installed with the bolt head facing inboard.
2. Loosely install the bushing bolts and nuts.
3. Place the axle on the hydraulic lift table.
4. Raise the axle into position.
5. Hand tighten the axle bracket to body bolts just enough to hold the brackets flush to the body.
Note: The axle through bolts must be tightened with the axle at the correct trim height and prior to torquing the axle bracket to body bolts.
