HHR L4-2.4L (2010)
Fluid Line/Hose: Service and Repair
Oil Feed Pipes Replacement
Oil Feed Pipes Replacement
Removal Procedure
Warning: Refer to Battery Disconnect Warning (See: Starting and Charging/Battery/Service Precautions)
1. Disconnect the negative battery cable.
2. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Remove the transmission oil pan. Refer to Oil Pan Replacement (See: Fluid Pan/Service and Repair).
4. Remove the transmission oil filter assembly. Refer to Automatic Transmission Fluid Filter and Seal Replacement (See: Fluid Filter - A/T/Service
and Repair).
5. Remove the oil feed pipe bolts.
6. Inspect the eight oil feed pipe seal rings.
7. Replace the seal rings only if the seal rings are cut, swollen or damaged.
8. Remove the low/reverse band oil pipe assembly.
9. Remove the eight low/reverse band oil pipe assembly seals.
10. Inspect the oil feed pipes for plugged passages, bent pipes, or cracks.
11. Inspect the oil feed pipe seal rings. Verify the proper location of the seal rings. Replace the seal rings if these are cut, swelled or damaged.
Installation Procedure
1. Install the eight low/reverse band oil pipe assembly seals.
