HHR L4-2.4L (2010)
Wiring Harness: Service and Repair
Wiring Harness Replacement
Special Tools
J 41101 Transaxle Connector Remover
Removal Procedure
1. Remove the transmission side cover. Refer to Control Valve Body Cover Replacement (See: Valve Body/Service and Repair/Control Valve Body
Cover Replacement).
2. Remove the control valve body. Refer to Control Valve Body Replacement (See: Valve Body/Service and Repair/Control Valve Body
Replacement).
3. Push the J 41101 onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's
retaining tabs.
4. With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
5. Remove the wiring harness (11).
Installation Procedure
1. Connect the wiring harness assembly to the following components:
*
The TFP switch assembly (13)
*
The pressure control solenoid (312) (red connector)
Important: The 1-2 shift solenoids wires are red and light green. The 2-3 shift solenoid wires are red and yellow.
