HHR L4-2.4L (2010)
3. Install the J 43482 in order to support the clutch cover to the flywheel assembly.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Tighten the clutch cover to flywheel bolts in the sequence shown to 30 Nm (22 lb ft).
5. Recheck each bolt torque using the tightening sequence.
6. Remove the J 43482 .
7. Install the transmission. Refer to Transmission Replacement (See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement).
8. Bleed the hydraulic system. Refer to Hydraulic Clutch System Bleeding (See: Clutch Hydraulic System/Service and Repair).
9. Connect the negative battery cable.
