HHR L4-2.4L (2010)
1. Install the rear transaxle mount to transaxle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Using the following sequence, install the rear transaxle mount bracket bolts:
1. Tighten the middle bolt to 90 Nm (66 lb ft).
2. Tighten the lower bolt to 90 Nm (66 lb ft).
3. Tighten the upper bolt to 90 Nm (66 lb ft).
3. Install the rear transaxle mount. Refer to Transmission Rear Mount Replacement (See: Transmission Rear Mount Replacement).
Transmission Rear Mount Replacement
Transmission Rear Mount Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).