Impala V6-3.5L VIN N (2006)
Battery Current Sensor: Service and Repair
BATTERY CURRENT SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
2. Remove the positive and negative battery cable.
3. Cut the tie straps and electrical tape attaching the battery current sensor to the positive battery cable.
4. Squeeze the positive and negative battery cable branches together.
5. Slide the battery current sensor (1) off of the battery cable.
IMPORTANT: Note the position of the battery current sensor prior to removal.
INSTALLATION PROCEDURE