Impala V6-3.8L SC VIN 1 (2005)
the plastic back shroud. Do not pinch the wire harness between the steering wheel urethane and the plastic back shroud.
4. Install the plastic back shroud to the back of the steering wheel with the shroud screws.
5. Install the radio controls wiring harness to the retainers in the steering wheel insert and back shroud. Verify that the wiring is not routed
underneath any of the four SIR module mounting holes in the steering wheel.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the shroud screws and the shroud on the back of the steering wheel.
Tighten the screws to 2 Nm (18 inch lbs.).
7. Install the steering wheel.
8. Install the inflatable restraint steering wheel module.
9. Enable the Restraints system.
