Impala V6-3.8L SC VIN 1 (2005)
Body Control Module: Removal and Replacement
BODY CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the battery ground (negative) cable.
IMPORTANT: You must perform the new body control module (BCM) setup when replacing the BCM. Refer to Control Module References.
2. Remove the left instrument panel insulator.
3. Disconnect the BCM electrical connectors (2,3,4).
4. Remove the BCM (1).
INSTALLATION PROCEDURE
1. Install the BCM (1).
2. Connect the BCM electrical connectors (2,3,4).
3. Install the left instrument panel insulator.
4. Connect the battery ground (negative) cable.
5. Perform the new BCM setup. See: Testing and Inspection/Programming and Relearning
