Impala V6-3.8L SC VIN 1 (2005)
5. Disconnect the electrical connector from the SOPS (3).
6. Remove the SOPS screw (2) from the switch.
7. Hold down on both drive cables, and lift straight up to remove the SOPS from the sunroof module.
INSTALLATION PROCEDURE
1. Keeping the position lock pin in the new SOPS, position the SOPS switch over the drive cables and press down.If the SOPS does not slide into
position, the ridges on the drive cable housings will not go into the grooves on the back of the SOPS. Lift each cable into the SOPS, and press
down on the SOPS assembly.
IMPORTANT: The new SOPS comes with a position lock pin that is installed on top of the SOPS. This locks the timing gears in place. Do not
remove this pin until after you have installed the SOPS and the actuator.
2. Install the Sunroof opening Position Switch screw (2) to the switch.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the SOPS screw to 2 N.m (18 lb in).
3. Connect the electrical connector to the SOPS .
4. Install the sunroof actuator.
5. Remove the position lock pin (1) or the 2 wires from the switch.
6. Remove the 2 pins from the cable/cam mechanisms.
7. Install the left and right front sunroof window panel screws.
