Impala V6-3.8L SC VIN 1 (2005)
1. Warm the rear compartment lid with J 25070 from the outside, to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing.
2. Peel the backing from the mounting surfaces of the rear end spoiler.
3. Align the rear end spoiler studs to the holes in the rear compartment lid.
4. Install the rear end spoiler to the rear compartment lid, pressing into place until the adhesive is fully seated.
5. Open the rear compartment.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Use new nuts/mastic washers in order to avoid a possible water leak.
6. Install the nuts to the rear end spoiler.
Tighten the rear end spoiler nuts to 6 N.m (53 lb in).
7. Close the rear compartment.
