Impala V6-3.8L SC VIN 1 (2005)
7. Connect the I/P module connector, located at the RH side of the I/P.
8. Install the CPA to the I/P module connector.
9. Install the RH I/P access hole cover.
10. Install the SDM fuse.
11. Install the LH I/P access hole cover.
12. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
13. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle in Vehicle DTC Information. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check -
Vehicle