Impala V6-3.8L SC VIN 1 (2005)
2. Connect the electrical connector to the hazard warning switch.
3. Press the I/P cluster trim plate into the I/P trim pad, until all of the retainers are fully seated.
4. Install the I/P cluster trim plate screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2 N.m (18 lb in).
5. For the Monte Carlo, install the left access cover to the I/P fuse block.For the Impala, install the right and the left access covers to the I/P fuse
block.
6. Install the steering column filler.
7. For the Monte Carlo, close the I/P compartment door.
8. Reposition the steering wheel to the original position.
9. If the vehicle is equipped with column shift, position the transaxle shift control indicator to Park.
10. Install the bezel to the ignition lock cylinder.
11. Release the parking brake.