Impala V6-3.8L SC VIN 1 (2005)
5. Install the wiring harness connector to the SDM.
6. Install the CPA to the SDM wiring harness connector.
7. Install the carpet and the passenger front carpet retainer.
8. Install the passenger front seat. Refer to Seat Replacement - Front Bucket in Seats.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9.
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set, requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check -
Vehicle
