Impala V6-3.8L SC VIN 1 (2005)
18. Secure and insulate the 3 wire connection to the deployment harness using electrical tape.
19. Connect the deployment harness to the steering wheel module connector.
20. Route the deployment harness out of the driver side of the vehicle.
21. Disconnect the inflatable restraint side impact module - LF connector (1), located under the driver seat.
22. Cut the side impact module - LF connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
23. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.