Impala V6-3.8L SC VIN 1 (2005)
Installation Procedure
Important: Follow this procedure exactly or the transaxle will have no reverse gear due to the servo pin missing the band.
1. Jack up the driver side of the car until the driver side is higher than the differential side. This ensures that the reverse band is in the proper location
and not cocked to the channel plate side of the case.
2. Install the servo spring (49).
3. Install the servo assembly (42-48).
4. Install the reverse servo cover (40) with the new O-ring seal (41).
5. Compress the servo cover (40) and install the snap ring (39).
6. Install the right exhaust manifold.
7. Install the exhaust crossover pipe.