Impala V6-3.8L VIN K (2004)
1. Position the wiper drive system module to the vehicle.
2. Connect the wiper motor electrical connector.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the wiper drive system screws.
Tighten
Tighten the screws to 10 N.m (89 lb in).
4. Using the J 39529 , Install the wiper transmission to the wiper motor crank arm.
5. Install the wiper motor water deflector.
6. Install the air inlet grille panel.
7. Inspect the wipers for proper operation.