Impala V6-3.9L (2007)
4. Place an adjustable jack and a block of wood under the oil pan.
5. Remove the engine mount bracket bolts.
6. Using the adjustable jack and block of wood, raise the engine until the engine mount/bracket can be removed.
7. Remove the engine mount/bracket from the vehicle.
Installation Procedure
1. Position the engine mount/bracket to the engine.
2. Install the engine mount bracket bolts.
Notice: Refer to Fastener Notice.
3. Tighten the engine mount bracket bolts.
Tighten the bolts in the sequence shown to 50 N.m (37 lb ft).
