Impala V6-3.9L (2007)
5. Install the engine mount strut to radiator support bolts.
Tighten the bolts to 50 N.m (37 lb ft).
Engine Support Fixture
Engine Support Fixture
Tools Required
*
J 28467-B Engine Support Fixture
*
J 36462 Engine Support Adapter Leg
1. Raise the hood.
2. Install the intake manifold cover.
3. Disconnect the negative battery cable.
4. Install the J 28467-33A thread support nuts onto the strut attaching studs.
5. Install the J 28467-5A strut tower support assemblies over the J 28467-33A thread support nuts.
6. Install the J 28467-5 T-bolts with 5/16-inch washers through the J 28467-5A strut tower support assemblies into the J 28467-33A thread support
nuts. Hand tighten the bolts.
7. Install the two J 28467-1A cross bracket assemblies over the J 28467-3 strut tower tube.
8. Install the J 28467-3 strut tower tube into the J 28467-5A strut tower support assemblies.
9. Install the J 28467-10 1/2-inch x 2.5-inch quick release pin through the J 28467-5A strut tower support assemblies and J 28467-3 the strut tower
tube on one side only.
