Impala V8-5.3L (2008)
8. Disconnect the antenna cable (1) from the antenna extension cable (2).
9. Cut off the visible end of the antenna cable from the wiring harness in the following locations:
*
The kick panel area
*
The rear shelf area
Installation Procedure
1. Install the antenna cable to the vehicle. Use electrical tape in order to secure the antenna extension cable to the top of the wiring harness. Secure
the cable to the harness at least every 150 mm (6 in).
Important: The antenna cable uses a sliding snap-lock. Holding the sliding lock feature will prevent installation.
2. Connect the antenna extension cable (2) from the radio to the antenna cable (1) near the kick panel:
1. Position the antenna extension cable behind the sliding lock feature.
2. Install the antenna extension cable to the sliding lock feature.
3. Install the carpet.
4. Install the right lower center pillar trim panel.
5. Install the right carpet retainers.
