chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Front Subframe|Service and Repair|Page 18334 > < Front Subframe|Service and Repair|Page 18332
Page 3
background image

1. If you are replacing the frame, install the following components:

*

Both of the lower control arms-Refer to Lower Control Arm Replacement.

*

The stabilizer shaft-Refer to Stabilizer Shaft Replacement.

*

The spacers, the upper insulator, the lower insulator, and the retainers-Refer to Front Frame Cushion or Insulator Replacement and to Rear
Frame Cushion or Insulator Replacement.

2. Position the engine support table with the frame under the vehicle.
3. Lower the vehicle to the frame.

4.  Loosely install the bolts (1) to secure the frame to the body.

Notice:  Refer to Fastener Notice.

5. Align the frame to the body by inserting two 19X203 mm (0.74X8.0 in) pins in the alignment holes (2) on the right side of the frame.

*

Tighten the new front frame bolts to 145 N.m (107 lb ft).

Front Subframe|Service and Repair|Page 18334 > < Front Subframe|Service and Repair|Page 18332