Impala V8-5.3L (2008)
Water Pump: Service and Repair
Water Pump Replacement
Water Pump Replacement (LS4) (5.3L)
Removal Procedure
1. Drain the cooling system. Refer to Cooling System Draining and Filling (9C1, 9C3 Static Fill) (See: Service and Repair)Cooling System Draining
and Filling (LZE, LZ4, LZG, 9C1, 9C3, GE47716 Fill) Cooling System Draining and Filling (LZE, LZ4, LZG, Static Fill) .
2. Remove the battery and battery tray. Refer to Battery Tray Replacement (LS4) Battery Tray Replacement (RPOs LZE/LZ4/LZ8) .
3. Remove the drive belt. Refer to Drive Belt Replacement - Accessory (See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive
Belt/Service and Repair) .
4. Remove the water pump bolts (318).
5. Remove the water pump (300) and gasket (314). Discard the gasket.
6. Clean and inspect the water pump gasket mating surfaces.
Installation Procedure
1. Install the water pump (300) and a NEW gasket (314).
Notice: Refer to Fastener Notice .
2. Tighten the water pump bolts (318).
Tighten the bolts to 10 N.m (89 lb in).
3. Install the drive belt. Refer to Drive Belt Replacement - Accessory (See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive
