Impala V8-5.3L (2008)
1. Install a NEW oil filter (452) and O-ring seal (454).
2. Apply sealant to the threads of the NEW oil pressure sensor.
Notice: Refer to Fastener Notice .
3. Install the oil pressure sensor (706) and washer (707).
Tighten the sensor to 20 N.m (15 lb ft).
4. Connect the oil pressure sensor electrical connector (4).
5. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (See: Intake Manifold/Service and Repair) .
