Impala V8-5.3L (2008)
1. Apply sealant to the threads of the oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers (See: Specifications/Adhesives, Fluids,
Lubricants, and Sealers) .
Notice: Refer to Fastener Notice .
2. Using J 41712 , install the oil pressure sensor (706) and washer (707).
Tighten the sensor to 35 N.m (26 lb ft).
3. Connect the oil pressure sensor electrical connector (4).
4. If necessary, install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (See: Intake Manifold/Service and Repair) .
