chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Antilock Brake System Automated Bleed Procedure|Page 3149 > < Antilock Brake System Automated Bleed Procedure|Page 3147
Page 3
background image

17. Install a transparent hose over the end of the bleeder valve, then repeat step 15.
18. After completing the final wheel hydraulic circuit bleeding procedure, ensure that each of the 4 wheel hydraulic circuit bleeder valves are properly

tightened.

19. Loosen the rear master cylinder jumper line nut slightly (just enough to rotate the line), and rotate the rear master cylinder hydraulic pipe back to

the original position, and tighten the line nut.

20. Reposition the front master cylinder jumper line to the original position in a similar manner to step 19.
21. Close the J 29532  , or equivalent, fluid tank valve, then disconnect the J 29532  , or equivalent, from the J 35589-A  .
22. Remove the J 35589-A  from the brake master cylinder reservoir.
23. Fill the brake master cylinder reservoir to the maximum-fill level with Delco Supreme 11(R) GM P/N 12377967 (Canadian P/N 992667), or

equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.

24. Slowly depress and release the brake pedal. Observe the feel of the brake pedal.
25. If the brake pedal feels spongy perform the following steps:

1. Inspect the brake system for external leaks. Refer to Brake System External Leak Inspection  (See: Brakes and Traction Control/Hydraulic

System/Testing and Inspection/Component Tests and General Diagnostics/Brake System External Leak Inspection) .

2. If equipped with Antilock Brakes, using a scan tool, perform the antilock brake system automated bleeding procedure to remove any air that

may have been trapped in the BPMV. Refer to Antilock Brake System Automated Bleed Procedure  (See: ) .

26. Turn the ignition key ON, with the engine OFF. Check to see if the brake system warning lamp remains illuminated.

Important:  DO NOT allow the vehicle to be driven until it is diagnosed and repaired.

27. If the brake system warning lamp remains illuminated, refer to Symptoms - Hydraulic Brakes  (See: Brakes and Traction Control/Hydraulic

System/Testing and Inspection/Symptom Related Diagnostic Procedures/Symptoms - Hydraulic Brakes) .

Antilock Brake System Automated Bleed Procedure|Page 3149 > < Antilock Brake System Automated Bleed Procedure|Page 3147