Impala V8-5.3L (2008)
Notice: Refer to Fastener Notice .
2. Install NEW wheel bearing/hub bolts.
Tighten the NEW wheel bearing/hub bolts to 130 N.m (96 lb ft).
3. Install the brake rotor and caliper. Refer to Front Brake Rotor Replacement .
4. Install the front wheel drive shaft nut. Refer to Wheel Drive Shaft Replacement (See: Transmission and Drivetrain/Drive Axles, Bearings and
Joints/Axle Shaft Assembly/Service and Repair) .
Important: Ensure that the connector clip engages the bracket properly.
5. Install the wheel speed sensor electrical connector to the bracket, if equipped.
6. Connect the wheel speed sensor electrical connector (2), if equipped.
7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair) .
8. Lower the vehicle.
