Impala V8-5.3L (2008)
*
GMLAN Wiring Repairs.
Scan Tool Does Not Communicate with Low Speed GMLAN Device
Scan Tool Does Not Communicate with Low Speed GMLAN Device
Diagnostic Instructions
*
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. See: Testing and Inspection/Initial Inspection and
Diagnostic Overview/Diagnostic System Check - Vehicle
*
Review Strategy Based Diagnosis for an overview of the diagnostic approach.
*
Diagnostic Procedure Instructions provides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
Modules connected to the low speed GMLAN serial data circuit monitor for serial data communications during normal vehicle operation. Operating
information and commands are exchanged among the modules when the ignition switch is in any position other than OFF. The low speed GMLAN serial
data circuit must be operational for the vehicle to start so the vehicle theft deterrent (VTD) module and body control module (BCM) can communicate.
The low speed GMLAN serial data circuit uses JX205 as the common connection between the modules and the data link connector (DLC).
Diagnostic Aids
*
Use the Data Link References to identify the low speed GMLAN serial data modules.
*
This test is used for a total low speed GMLAN communication failure. If only 1 module is not communicating and sets no DTC, ensure that the
vehicle is equipped with the module, then use DTC U0100-U0299 for diagnostics.
*
An open in the low speed GMLAN serial data circuit between the splice pack and a module will only effect the specific module. This type of
failure will set a loss of communication DTC for the module effected, and the other modules will still communicate.
*
An open in the DLC ground circuit terminal 5 will allow the scan tool to operate to set up the vehicle on the tool and then not communicate with
the vehicle. When the scan tool is to the point of communicating with the vehicle, a message on the scan tool will indicate "no CANdi module
detected" and will not communicate. The vehicle modules will still communicate, and the vehicle will start.
*
An open between the DLC and JX205 will only effect the communication with the scan tool. The vehicle modules will still communicate, and the
vehicle will start.
*
The engine will not start when there is a total malfunction of the low speed GMLAN serial data circuit.
The following conditions may cause a total loss of low speed GMLAN data communication:
-
The low speed GMLAN serial data circuit shorted to ground or voltage.
-
A module internal malfunction that causes a short to voltage or ground on the low speed GMLAN circuit.
Circuit/System Testing
Low Speed GMLAN Initial Test
1. Test for less than 1 ohm of resistance between the DLC ground circuit terminal 5 and ground.
^
If greater than the specified range, test the ground circuit for open/high resistance.
2. Ignition OFF, disconnect the harness connector (splice pack comb) at JX205. Test for infinite resistance between the following JX205 serial data
circuit terminals and ground.
*
Terminal A
*
Terminal B
