chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Campaign - A/C Control Module Reprogramming|Page 263 > < Campaign - A/C Control Module Reprogramming|Page 261
Page 3
background image

DO NOT turn OFF the ignition if the programming procedure is interrupted or unsuccessful. Ensure that all control module and DLC connections
are secure and the TIS terminal operating software is up to date. Attempt to reprogram the control module. If the control module cannot be
programmed, replace the control module.

1.

Verify that there is a battery charge of 12 to 16 volts. The battery must be able to maintain a charge during programming. Only use approved
Midtronics PCS charger, a fully charged 12V jumper, or booster pack disconnected from the AC voltage supply to maintain proper battery voltage
during programming.

2.

Reprogram the HVAC control module. Refer to SI and Service Programming System (SPS) documentation for programming instructions, if
required.

2.1

Connect the MDI or Tech2(R) to the vehicle.

Important:

Select J2534 MDI or Tech 2(R) Legacy Pass-Thru and Reprogram ECU from the Select Diagnostic Tool and Programming Process screen.
The J2534 MDI will reprogram the module in less time than the Tech 2(R) scan tool.

2.2.

Select HVAC Control Module from the Supported Controllers screen.

2.3.

Follow the on-screen instructions. Select HVAC Control Module with Manual Dual Zone (RPO CJ3).

2.4.

Select Latest New Calibrations to Enable OAT for use with up level instrument panel (RPO UH8).

3.

Using the MDI or Tech 2(R), clear all DTCs if required.

Courtesy Transportation

The General Motors Courtesy Transportation program is intended to minimize customer inconvenience when a vehicle requires a repair that is covered
by the New Vehicle Limited Warranties. The availability of courtesy transportation to customers whose vehicles are within the warranty coverage period
and involved in a product program is very important in maintaining customer satisfaction. Dealers are to ensure that these customers understand that
shuttle service or some other form of courtesy transportation is available and will be provided at no charge. Dealers should refer to the General Motors
Service Policies and Procedures Manual for Courtesy Transportation guidelines.

Claim Information

Submit a Product Claim with the information shown above.

Refer to the General Motors WINS Claims Processing Manual for details on Product Recall Claim Submission.

Customer Notification

General Motors will notify customers of this program on their vehicle (see copy of customer letter shown in this bulletin).

Dealer Program Responsibility

All unsold new vehicles in dealers' possession and subject to this program must be held and inspected/repaired per the service procedure of this program
bulletin before customers take possession of these vehicles.

Campaign - A/C Control Module Reprogramming|Page 263 > < Campaign - A/C Control Module Reprogramming|Page 261