Impala V8-5.3L (2008)
15.
Install the stabilizer shaft to the rear suspension support.
16.
Install the rear wheel spindle rod bolts and nuts to the knuckles (both sides).
Tighten
Tighten the nuts to 150 Nm (110 lb ft).
17.
Install the wiring harness clips to the spindle arms and to the connector at the body.
18.
Install the exhaust pipe/muffler assembly.
19.
Inspect the rear tires for uneven wear. Inspect the tread depth at the inboard and outboard tread blocks, and if there is more than 2.4 mm (3/32 in)
difference in wear, install two new tires. If the customer has replaced the original Pirelli tires with four lower speed rated tires, install the same
brand or comparable tire that was removed.
20.
Install the rear tires and wheels.
21.
Lower the vehicle.
22.
Adjust the wheel toe angle.
