Impala V8-5.3L (2008)
Wheel Fastener: Service and Repair
Front Suspension
Wheel Stud Replacement
Tools Required
J 6627-A Tie Rod Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Service and Repair) .
3. Without disconnecting the hydraulic brake hose, remove and support the brake caliper and bracket as an assembly.
4. Remove the brake rotor. Refer to Front Brake Rotor Replacement .
5. Rotate the bearing hub to a position where the least amount of interference between the stud and the steering knuckle exists.
6. Using the J 6627-A , release the wheel stud (1) from the bearing hub (2) and discard the stud.
Important: Some models may require additional clearance for stud removal.
7. If necessary, loosen the wheel bearing/hub assembly retaining bolts enough to walk the bearing away slightly from the knuckle. Refer to Front
Wheel Bearing and Hub Replacement (See: Wheel Bearing/Service and Repair/Front Suspension) .
Installation Procedure
