Impala V8-5.3L (2008)
2. Remove the oil reservoir weir (27).
Installation Procedure
1. Install the oil reservoir weir (27).
2. Install the case side cover. Refer to Control Valve Body Cover Replacement (See: Valve Body/Service and Repair/Control Valve Body Cover
Replacement) .
Transmission Fluid Cooler Hose/Pipe Connector Replacement
Transmission Fluid Cooler Hose/Pipe Connector Replacement
Removal Procedure
Notice: Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause fluid
loss.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Position a drain pan under the vehicle.
3. Remove the transaxle oil cooler hoses from the transaxle oil cooler fittings. Refer to Transmission Fluid Cooler Hose/Pipe Replacement (See: ) .
4. Remove the transaxle oil cooler fittings (28, 29) from the transaxle.
Installation Procedure
