Impala V8-5.3L VIN C (2006)
6. Install a large C-clamp (3) over the top of the brake caliper (2) and against the back of the outboard brake pad.
7. Tighten the C-clamp (3) until the caliper piston is pushed into the caliper bore enough to slide the caliper off the rotor.
8. Remove the C-clamp (3) from the caliper.
9. Remove the brake hose-to-caliper bolt (1) from the caliper. Discard the 2 copper brake hose gaskets (3). These gaskets may be stuck to the brake
caliper and/or the brake hose end.
10. Plug the opening in the rear brake hose (2) to prevent excessive brake fluid loss and contamination.
11. Remove the caliper bolts (1 and 3).
12. Remove the caliper (3) from the rotor (4) and the caliper bracket (1).
