Impala V8-5.3L VIN C (2006)
7. Remove the rear window reveal molding (1).
Grasp the lower corner of the window reveal molding by hand and slowly pull the reveal molding away from the window.
If the rear window reveal molding will not release, use a utility knife in order to cut around the rear window in order to remove the window reveal
molding.
Important: Keep the cutting edge of the tool against the window.
8. This will allow the urethane adhesive to be separated from the window.
*
Leave a base of urethane on the pinch-weld flange.
*
The only suitable lubrication is clear water.
*
Use J 24402-A, J 39032 or equivalent in order to remove the window.
9. With the aid of an assistant, use the suction cups in order to lift the rear window from the opening.
Installation Procedure
1. Install the rear window into the opening.
2. Connect the OnStar(R) connector, if equipped.
3. Connect the rear window defogger electrical connector, if equipped.
