chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 9336 > < Initial Inspection and Diagnostic Overview
Page 2
background image

^

Clear or light yellow dot - Battery electrolyte is low. Replace Battery.

2. Check that Starter Solenoid Switch terminals "S" and B" and Battery connections are clean and tight.
3. Check that Maxifuse #11 and I/P Fuse #24 are OK. If these fuses are open, check for a short to ground in CKT 5, CKT 142 or CKT 806.
4. Check that G100 and G101 are clean and tight.
^

Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a
continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be
checked by monitoring for a voltage drop with the system operational (under load).

^

Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (refer to "General
Troubleshooting Procedures,").
  See: Diagrams/Diagnostic Aids

^

Refer to System Diagnosis.

Initial Inspection and Diagnostic Overview|Page 9336 > < Initial Inspection and Diagnostic Overview