K 1500 Suburban 4WD V8-5.3L VIN T (2002)
1. Install the anti-rattle clips to the brake caliper bracket.
2. Install the brake pads to the brake caliper bracket.
^
Install the inner pad-1 wear indicator.
^
Install the outer pad-2 wear indicators.
3. Install the brake caliper to the mounting bracket.
4. Install the tire and wheel assembly.
5. Lower the vehicle.
6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
9. Fill the master cylinder reservoir to the proper level with clean brake fluid.
10. Burnish the brakes pads and rotors as necessary.
