K 1500 Suburban 4WD V8-5.3L VIN T (2002)
4. Use a backup wrench on the brake hose fitting end (1), disconnect the brake pipe fitting end (2) from the brake hose (1) then cap or plug the brake
pipe fitting end.
5. Remove the brake hose retaining clip (3) from the brake hose mounting bracket.
6. Remove the brake hose (1) from the mounting bracket.
7. Remove the brake hose to caliper bolt from the brake caliper.
8. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
Installation Procedure
Important: Install 2 New copper brake hose gaskets.
1. Assemble the 2 New copper brake hose gaskets and the brake hose bolt to the brake hose.
Notice: Refer to Fastener Notice in Service Precautions.
