K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
Power Window Control Module: Service and Repair
Module Replacement - Rear Power Window (Ext)
MODULE REPLACEMENT - REAR POWER WINDOW (EXT)
REMOVAL PROCEDURE
1. Raise and support the window glass.
2. Remove the trim panel.
3. Remove the water deflector.
4. Disconnect the window motor electrical connector.
5. Loosen the two window clamp bolts on the regulator.
6. Remove the bolts retaining the window regulator to the door.
7. Remove the module from the door.
INSTALLATION PROCEDURE
1. Install the module to the door.
2. Install the bolts retaining the regulator to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 9 N.m (7 lb ft).
3. Align the window to the regulator, and tighten the clamp bolts.
