K 1500 Suburban 4WD V8-5.7L VIN R (1996)
Rocker Arm Assembly: Service and Repair
Valve Rocker Arm Stud Remove and Install
Rocker arm stud removal
Rocker arm stud installation
Remove the old stud by placing a suitable spacer over the stud, Fig. 13. Install a nut and flat washer on the stud and pull out the stud by turning the
nut. After reaming the hole for an oversize stud, coat the press-fit area of the new stud with rear axle lubricant. Install the stud using stud driver tool
No. 6880, or equivalent, by driving it in until tool bottoms on the head, Fig.14.
