K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
License Plate Lamp: Service and Repair
Endgate Identification Lamp Replacement
REMOVAL PROCEDURE
Replace the lens, the lamp, and the base as one assembly.
1. Make sure the headlamp switch is in the OFF position.
2. Remove the lens.
3. Remove the 2 screws.
4. Remove the lamp assembly.
5. Disconnect the electrical connector.
INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the lamp assembly to the endgate.
3. Install the 2 screws.
4. Install the lens.