K 1500 Truck 4WD V8-305 5.0L (1988)
Drive/Propeller Shaft: All Technical Service Bulletins
Driveline - Propeller Shaft Noise/Center Bearing Wear
Number:
88-372-4A
Section:
4A
Date:
DEC., 1988
Subject:
CENTER BEARING ISOLATOR WEAR AND
PROP SHAFT NOISE
Model and Year:
1988 EXTENDED CAB K1, 2, 3
TO:
ALL CHEVROLET DEALERS
The rear propeller shaft in the 1988 K extended cab is a steel two piece design with a center bearing. As the suspension articulates, the shaft between the
transfer case and the center bearing may be drawn rearward causing contact with the center bearing isolator. The result could be a noticeable noise and
center bearing wear.
The 2 piece propeller shaft in the 1989 K extended cab has been redesigned. The new center bearing has a rear extension. The transfer case to center
bearing prop shaft has a necked down 3" spline and the rear prop shaft has a pop-on seal in front of the slip yoke.
When encountered, center bearing isolator wear and prop shaft noise in 1988 K extended cab can be corrected by replacing the two rear propeller shafts
and center bearing using the new design (1989) parts and the procedure in the 1988 C/K Service Manual, Section 4A.
Parts
Parts are currently available from GMSPO.
Front Propeller Shaft
Rear Propeller Shaft
Model
Part Number *
Part Number
K10953-M20
15622415
15622431
K10953+M20
15622417
15622427
Front Propeller Shaft
Rear Propeller Shaft
Model
Part Number *
Part Number
K20953
15622417
15622428
K30953-R05,-L19
15622417
15622428
K30953-R05,+L19
15622417
15622429
*
Front Propeller Shaft P/N includes Center Bearing
Note:
M20 = 117 mm 4 Spd. Transmission R05 = Dual Rear wheel L19 = 7.4L TBI
For vehicles repaired under warranty, use:
Labor Op:
F1280