K 2500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1996)
Removing Pulley
Installing Pulley
REMOVE OR DISCONNECT
NOTE: Make sure the engine control switch is off.
1. Vacuum pump (1) and bracket (10) assembly from the vehicle.
2. Bolts holding the mounting bracket (10) to the engine.
3. Nut holding the bracket to the stud on the engine.
4. Vacuum pump and the bracket from the engine.
DISASSEMBLE
Tool Required:
J 25034-B Pump Pulley Remover
-
Clamp the vacuum pump bracket in a vise.
1. Pulley (2) from the pump using tool J 25034-B.
CAUTION: Do not pry from the back of the pulley. Damage could occur to the pulley or pump.
2. Three bolts (11) from the back of the bracket.
3. Vacuum pump.
ASSEMBLE
Tool Required:
J 25033-B Pump Installer
1. Vacuum pump to the bracket with bolts (11).