K 2500 Truck 4WD V8-350 5.7L VIN K TBI (1995)
Important: Scribe a line on the pinion stem, pinion nut and pinion flange to be used as an installation guide.
2. Nut using J 8614-01.
3. Flange using J 8614-01.
4. Oil seal.
-
Use the special nut and forcing screw to remove the flange.
-
Pry the oil seal from the bore. Do not damage the machined surfaces.
-
Thoroughly clean foreign material from the contact area.
Inspect
-
Oil seal mating surfaces for any burrs which may cause seal failure.
-
Flange deflector for any abnormality such as cracking or distortion.
-
Replace any part which shows any of the above conditions.
INSTALL OR CONNECT